ENG DES I (EN)

General Information

Timetable

Start: 1st October 2015
End:  7th January 2016

 Classroom: A1 - 504

Assessment
Deadline for hand-over of all tasks: 21.1.2016 (after this date no drawings will be accepted)
Assessment: Test of knowledge and sketching. Time will be clarified

Requirements: 
Completed and by teacher signed all 4 given tasks.
Active participation at lectures and seminars.

Test requirements
Test example

Each of tasks is evaluated by same amount of points (3). To be successful in the test it is necessary to reach at least 15 points.

Lecture notes
Standards and Study Resources
Drawing Templates
- Standards sheet format A3 and A4
- Standards sheet format A3 and A4 with gear designation table
- Drawing templates for Autodesk Inventor 2015 (.idw)
- Drawing templates for Autocad and other CADs (.dwg)
- Part list templates

Standards Selection (ED 1)
- Threads
- Thread termination, grooves
- Holes for bolts
- Standard parts (Bolts, Washers, Nuts)
- Knurling
- Keys, Keyways
- Lock-Plates
- Retaining Rings
- Lock-nut and Lock-washer

- V-Belt Belts and Pulleys
- Synchronous drive Belts and Pulleys
- Steel Roller-Chains
- Splines and Serrations (ČSN 01 4933, ČSN 01 4942, ČSN 01 4952)
- Involute Gears, module
- Semi-products (Round bars, Flat bars, . . .)
Subscribe to: Posts (Atom)